DIYmall HC-SR505 Motion Sensor for Arduino

The material you need prepare is:

1 X HC-SR505 Motion Sensor
1 X DIYmall UNOR3 with USB cable
1 X 3P Male to Female Jumper Wire
1 X LED

DIYmall UNOR3 & HC-SR505 PIR Sensor & led & Hookup wires

Wiring Connection:

HC-SR505 to DIYmall UNOR3:

– to GND
out to D7
+ to 5V

LED to DIYmall UNOR3:

Red LED long pin to D13
Red LED short pin to GND

Wiring diagram for DIYmall UNOR3 with HC-SR505 and LED

 

Code example:

int SR505=7;
int LED=13;
void setup()
{
pinMode(LED,OUTPUT);
pinMode(SR505,INPUT);
Serial.begin(9600);
}
void loop()
{
if(digitalRead(SR505)==HIGH)
{
Serial.println(“Enter The Sensing Area “);
digitalWrite(LED,HIGH);
delay(10);
digitalWrite(LED,LOW);
delay(10);
}
else
{
Serial.println(“NO Man”);
digitalWrite(LED,LOW);
}
delay(500);
}

Running the code, and get the result like below picture:

Purchase link:

HC-SR505 mini PIR motion sensor:

https://www.diymalls.com/HC-SR501-HC-SR505-AM312-PIR-Sensor-Module-HC-SR501-Mounting-Bracket

DIYmall UNOR3:

https://www.diymalls.com/DIYmallUNO-R3-Development-Board-ATmega328P-Microcontroller

*************************************************************************************

*************************************************************************************