SIM800L Flash Firmware

We will flash SIM800H firmware to this module, firmware download link:

https://simcom.ee/documents

We download this firmware:

SIM800L Module Pinout:

Connection: ( Here, I power it with 3.7V lithium battery, you can

power it with DC power supply too)

SIM800L            CP2102                  3.7V battery

VCC                                                          Positive

RST                                                         Negative

TX                             RX

RX                            TX

GND                       GND                      Negative

Note: RST need connect with switch and negative of battery

After connected, the blue LED of the SIM800L will blink fast.

Flash tool download link:

http://surl.li/bdcsr

After download, please install flash tool:

Open flash tool, and make setting as below and choose the firmware file :

About the COM port, please check it in your computer’s device manager.

Click Start Download, then press the switch, it will begin to download

It need download several files, and will take a few minutes

When downloading, the TX and USBGND LED of CP2102 serial port module will turn on, LED of SIM800L will turn off.

If you see this message, just click OK

Once click OK, it will show this, that means success.

Remove RST cable and open serial port software, you can send ATI and AT command, then you will see below message:

Reference link:
https://www.youtube.com/watch?v=YOG7x_UbTPQ

Firmware download link: (please download SIM800H)

https://simcom.ee/documents

 

Note: If this firmware can not flash success, you can download other firmware  and try.

Leave a Reply

Your email address will not be published. Required fields are marked *