DIYmall Ublox NEO-6M Arduino GPS Module with EEPROM

 

 1   Please solder the pin header, then connect like this
GPS module        Arduino
VCC                            5V
GND                          GND
RX                              4
TX                               3

2     Connect UNO R3 to your computer
y
ou can download library from this link:
https://github.com/mikalhart/TinyGPSPlus
as the default baud rate for this gps module is 9600, so you need change static const uint32_t GPSBaud = 9600 to static const uint32_t GPSBaud = 4800, after uploading the code, you can open the serial monitor , please choose Both NL&CR 115200 baud, then you can get the GPS , below is the information I got:

 

Any question please feel free to contact

Email:sales@diymalls.com
Skype:freezone992
Phone/Whatsapp/Wetchat:0086-18576406709

Website:www.diymalls.com

Amazon link https://www.amazon.com/dp/B01H5FNA4K

Aliexpress link http://s.aliexpress.com/IjYvYFja

Leave a Reply

Your email address will not be published. Required fields are marked *